tlp works wonders for keeping system under control. 10 seconds later turbo is turned back on and temperatures immediately spike back up to 72☌.Īfter knowing your temperature you probably want to control it better. ![]() Then turbo is switched off and temp drops 10☌ to 62☌ with a non-turbo speed of 2600 MHz. ![]() The temperature starts at 72☌ with a single CPU running at 100% in turbo mode of 3200 MHz. Within conky the system variable I used to monitor an Ivy Bridge CPU is: $☌ If you don't mind third-party utilities I like to use Conky-a light weight system monitor. For the Skylake i7 6700HQ CPU, I used this temperature for Conky display below. The last temperature is x86_pkg_temp reported at 54.0☌. The temperatures are stored in Celsius with 3 implied decimal places. To see what zones the temperatures are referring to use: $ paste <(cat /sys/class/thermal/thermal_zone*/type) <(cat /sys/class/thermal/thermal_zone*/temp) | column -s $'\t' -t | sed 's/\(.\).$/.\1☌/' If you want to find out the temperature without installing anything, use: $ cat /sys/class/thermal/thermal_zone*/temp ![]() To see HDD temperature Install hddtemp sudo apt-get install hddtempĪt the time of writing, all the answers involve use of third-party utilities. ![]() Finally to get your CPU temperature type sensors in your terminal. You may also need to run sudo service kmod start Install lm-sensors sudo apt-get install lm-sensorsĪfter installation type the following in terminal sudo sensors-detect
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |